E100 Epoxy Coating System

E100 is a 100% solids, low viscosity, self-leveling epoxy coating with excellent adhesion to concrete and metal substrates. E100 can be used as a concrete sealer or as a topcoat. E100 can be used in chip and metallic systems and is compatible to K100FLEX.

3 gallon kit, 15 gallon kit, 150 gallon kit

Concrete structures must be cured a minimum of 28 days prior to application. Surfaces to be coated must be free of grease, standing water and any other contaminants that may impede adhesion. Always check the surface for any bond inhibitors prior to application. Any repairs must be addressed prior to application and should be repaired in accordance with ICRI standards. Concrete must have a surface profile of CSP #3. If concrete does not meet a profile of CSP #3 it must be profiled mechanically to meet CSP #3. Repair all cracks and joints prior to coating application. Bare metal substrates must be prepared to a SSPC SP 1 standard.

Note: Maintaining a consistent storage temperature prior to application will maximize working time. Material should be kept in a cool dry place prior to application.

Mixing Part A with Part B: Mix 2 parts E100 to 1 part EZ150. Mix for 3 minutes. No induction time is required prior to use. If micro-media agents are to be incorporated, they are to be added after thoroughly mixing A and B.

Suggested application thickness is 8 mils or 200 ft per coat, per gallon. Refer to Quadex® tech docs directly for specifics on effective application techniques. Maximum application mil thickness in a single application is 10-12 mils. Material will be dry to the touch 4 hours after application, dependent on ambient temperature, slab temperature and humidity. Product may be re-coated within 4-24 hours following application. Light foot traffic is acceptable 12 hours following application and vehicular traffic is acceptable 48 hours after application.

Use MEK or Acetone